The EP Greenhouse gear driver is a compact and lightweight reduction reducer with an integrated limit switch system that’s ideal for assembly of a locally available electric engine. The gear reducer is utilized in manually-managed or climate-managed ventilation and screen systems in greenhouses. The quick and easy-to-install EP gear driver is rainproof and windproof. The gear motor has a high protection class (IP65) and can be utilized within an ambient temperature of 0-60 °C.
The low-noise geared motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmitting ensures that the drive shaft is certainly locked when the reduction gear driver is not running. The fully sealed reduction gear reducer has an growth chamber with a diaphragm to keep carefully the gear essential oil at a minimal pressure under all situations, even at high temps. Thanks to the use of an growth chamber, the gear motor could be installed in any position. There are no limitations, since there is no dependence on a bleed connect. The sealed reduction gear motor keeps the apparatus oil of the geared motor in optimum condition because of its entire operating lifetime. The gear driver is ideal for discontinuous use, operating class s3-30%, with a maximum activation period of 25 minutes.
The Gear box reduction gear driver comes with an FT85 motor assembly flange, on to which the right IEC standard motor can simply be installed (EN 50347).
The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit change system is installed within an built-in chamber and can be enclosed by an impact-resistant plastic cover. The limit change system is obtainable and simple to adjust. The limit switch system’s maximum switching range is definitely 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The gearbox comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The gearbox for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of software of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, maximum activation time 25 mins.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC regular motor (EN 50347).
Maximum switching selection of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).