Power UNITS FOR LIFT TABLE 1
Common Description
This power unit is intended solely for that compact lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has been extensively employed from the field of logistic products for instance minifork lift, scissors lift and ariel working platforms. The lower-ing motion is controlled by the solenoid valve with all the velocity controlled through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This energy unit is built solely for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve along with the velocity managed through the adjustable needle valve. When the lift rises to a large positoin, however the electrical power supply is cut, the reducing motion is controlled by the manual override function.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This power unit is created solely to the big lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve along with the pace controlled by a pressure compensated flow control valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This electrical power unit is made solely for that large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve plus the velocity controlled by the adjustable needle valve. When the lift rises to a higher positoin, but the power supply is reduce, the lowering motion is controlled through the guide override function.
Particular Notes
one. This power unit is of S3 duty cycle, which might only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean each of the hydraulic parts concerned prior to installation of the energy unit.
3. Viscosity on the oil shoud be 15~46 cst,which ought to also be clean and free of charge of impurities.N46 hydraulic oil is advisable.
4. Oil shifting is required following the preliminary one hundred operation hrs,afterwards once every 3000 hrs.
five. The power unit shown is intended to be mounted vertically.